Patio Door Installation Day — What to Expect, Start to Finish
Send one photo from the deck and one from inside, plus the sill corner.
Reply within one business day. Or call / text 763-250-3621.
How a sliding glass door is installed: the old unit comes out whole, the sill and subfloor are probed for rot, a sill pan goes down, and the new frame is set level, shimmed, fastened and flashed into the house wrap. Interior and exterior trim go on last. For one two-panel slider in a sound opening, JMB Builders is on site most of a day, priced per door.
- One slider in a sound opening: most of a day
- Wall open a few hours, closed the same day
- MN Lic. BC809005

By install day the choices are made. The opening was measured in person, the door was ordered in the right size, panel layout and jamb depth, and the quote lists the door, the install and any trim. Nothing comes apart until the new door is on site, unwrapped and checked against the order: size, which panel slides, glass, grilles and color.
A patio door is a big hole in the wall, six to eight feet wide, so the day runs in a set order to keep the wall open as short a time as possible. The deck by the door is covered, runners go down inside, and the steps below repeat on every patio door we set.
The sill is where old patio doors fail. Water gets past a worn threshold and sits on the subfloor and rim joist for years before anyone sees it. Once the old door is out, we probe the wood. Soft wood is photographed, shown to you and priced before it is cut out. If the repair runs past the day, the opening is closed with a temporary panel and secured; it is never left open overnight.
The last step is a walkthrough with you. You slide the door, lock it, set the screen and check that it latches. The finished photos go in your job folder. Painting is quoted as a separate line — or leave it primed and caulked and paint it yourself.
Hail or wind damage? Start with the 10-minute window and door check. · How a storm claim works with us
Get a written quote for this job
Three photos and a sentence is enough: a reply within one business day, or ask for a free in-home estimate. Or text the photos to 763-250-3621.
What you supply
- A clear path from the driveway to the deck or patio for a long, heavy door
- Furniture, rugs and blinds moved back several feet from the door inside
- Grill, planters and deck furniture moved off the boards in front of the door
- Pets and kids kept out of the room while the wall is open
- Someone home at the start to confirm the door and at the end for the walkthrough
What JMB supplies
- Covers on the deck boards and steps, and runners on the floor inside
- The new door, checked against the order before the old one comes out
- Removal and haul-away of the old door, frame, trim and debris
- Sill pan, flashing tape, low-expansion foam, sealant, shims and fasteners
- Exterior trim and interior casing, caulked and ready for paint
- Panels, rollers, lock and screen adjusted so the door slides and latches
- A walkthrough with you, and photos of the finished door in your job folder
How it is priced: per door
Quoted in writing from your photos, with a reply within one business day. What moves the number:
- Rot in the sill framing, subfloor or rim joist found once the old door is out
- Slider or hinged French door, and two, three or four panels
- A new opening size, which means reframing the header or the studs
- Siding, stucco or brick around the door and how the exterior trim ties in
- Interior casing kept and reset, or new casing and extension jambs
- A deck or step right at the sill that has to be worked around
- Painting the trim, quoted as a separate line
Send one photo from the deck and one from inside, plus the sill corner. We reply within one business day. Or book a free in-home estimate.
How long it takes
One two-panel slider in a sound opening: most of a day on site, with the wall open a few hours. Rot repair, a French door or a new opening size adds time. These are typical, not promises.
How your project works
- 1
Arrive, cover, check the door
The deck and steps by the door are covered and runners go down inside. The new door is unwrapped and checked against the order before anything is removed.
- 2
Old door out
Inside casing comes off, exterior trim and caulk are cut, the panels come out, and the old frame leaves in one piece.
- 3
Sill and subfloor checked
The sill framing, subfloor and rim joist are probed. Soft wood is shown to you, priced and replaced. The opening is checked for level and square.
- 4
Sill pan, set and shim
A sill pan goes down with an upturned back edge. The frame is set in sealant, shimmed level and plumb, and fastened through the jambs. The panels go back in.
- 5
Flash, foam and trim
Flashing tape is lapped into the house wrap, sides first and head last. Low-expansion foam fills the gap, then the exterior trim and interior casing go on and are caulked.
- 6
Walkthrough and cleanup
You slide, lock and latch the door and set the screen. The old door and debris are hauled away and the floor is cleaned.
Situations and options
Slider in a sound opening
The common case. The old two-panel slider comes out, the sill and subfloor are solid, and the new slider goes into the same opening.
Rot under the sill
Years of water past a worn threshold leave the subfloor or rim joist soft. The bad wood is cut out and replaced with new framing before the sill pan goes down. You see it and the price before it is done.
French or hinged patio door
A hinged pair or a single hinged door with a fixed panel. Same steps, plus hanging and adjusting the doors and the latch, so it takes a full day.
Winter install
The room is closed off with a plastic wall, only one opening is open at a time, and snow is cleared back from the sill. Tape and sealants are cold-rated.
Door onto a low deck or step
When the deck boards sit close under the sill, there is less room for the sill pan and the exterior trim. A board or two at the door may come up and go back so the sill drains.
New opening size
Going from a five-foot to a six-foot slider, or a slider to a wider unit, means new framing at the sides and a header sized for the span. That is planned and priced on the quote, not found on the day.
Patio Door Installation Day — What to Expect, Start to Finish: questions, answered
How long does a patio door installation take?
For one two-panel slider in a sound opening, most of a day on site. The wall itself is open a few hours, between pulling the old frame and fastening the new one. Rot under the sill, a French door, a new opening size or a stucco or brick wall adds time. These are typical times, not promises. The quote says how long we expect your job to take, and we tell you that day if we find something that changes it.
Do I need to be home?
Someone should be home at the start and at the end. At the start you confirm the door, which panel slides and where the work area is. At the end you do the walkthrough: slide the door, lock it, set the screen and check that it latches without a push. In between you do not have to be there, but the wall will be open for a few hours, so plan where pets and kids will be and keep them out of that room.
What if the subfloor is rotted?
We stop and show you. Once the old door is out, the sill framing, subfloor and rim joist are probed, and soft wood is photographed and priced before it is cut out. Most sill repairs get done the same day, and the sill pan goes onto dry, solid wood. If the repair is bigger than one day, the opening is closed with a temporary panel and secured. It is never left open overnight.
Can you install a patio door in winter?
Yes. The new door is on site and checked before the old one comes out, and the room is closed off with a plastic wall so the cold stays in that room. Only one opening is open at a time, for a few hours. Snow and ice are cleared back from the sill, and wet wood is dried before the sill pan goes down. Exterior paint or caulk that needs a warmer day can wait for a short visit in spring.
Will my deck or flooring be damaged?
The deck boards and steps by the door are covered before work starts, and runners go down inside from the door to the work area. The doors come in and out on that path. If deck boards sit tight under the old sill, one or two may need to come up and go back so the sill pan drains; we tell you before we touch them. The floor is cleaned before we leave.
What should I do to prepare?
Clear a path from the driveway to the deck or patio; a patio door is long and heavy. Inside, move furniture, rugs and blinds several feet back from the door. Outside, move the grill, planters and deck furniture off the boards in front of it. Plan for pets and kids while the wall is open, and leave room in the driveway for the trailer. Take a photo of anything near the door you want back where it was.
Recent JMB work, from our job log
59 installs recorded across 30 Twin Cities communities since Dec 2025. Window and door installs for homeowners and the builders we work with. Counts come straight from our job log; no customer names.
Every door, two together, or just one
Send photos and we reply within one business day, or book a free in-home estimate.
Related jobs we do
Sliding Glass Door Replacement and Installation — Minnesota
The slider drags, the glass fogs, and the floor inside the sill is dark. You pick the new door; we order it to fit, fix what is under the old one and set it so it glides.
Read moreFront Door Installation: What to Expect From Arrival to Walkthrough
The door is ordered and the date is set. Here is what happens at your front entry that day, step by step, and what you need to do before we arrive.
Read moreWindow Installation Day: What to Expect, Arrival to Walkthrough
The windows came in, the date is set, and the trailer pulls up in the morning. Here is how the day runs.
Read morePatio Door Replacement in Winter — One-Day Swap, House Kept Warm
Frost on the inside of the slider, ice on the track, a cold draft across the kitchen floor, and it is January. The door can be replaced now; the day just runs a little differently.
Read morePatio Door Replacement Cost Factors — What Moves the Price
You want a number for a new patio door, and every company gives one without saying what is in it. This is what moves the price, and how our quote shows each part.
Read moreFrench Patio Door Replacement — Hinged Pair Supplied, Set and Sealed
The old French doors leak at the sill, the pair no longer lines up in the middle, and one door has to be lifted to lock. We order a new pair to fit and set it right.
Read morePage reviewed November 22, 2026 · JMB Builders LLC, MN license BC809005 · All doors pages
Where we work
Door Replacement & Installation near you
Based in Zimmerman, scheduling across the Twin Cities metro. A few of the towns we cover: